Strength Of Materials

Données Générales
Programme Académique	ECAM LaSalle Mechanical and Electrical Engineering Programme			Responsable(s) Module : ANKOUNI Mouhamad,SAYILAN Aslihan
Type d'EC : Cours	Strength Of Materials (LIIEEng05EStrengthMat)
TD : 12h00 TP : 8h00 Cours : 12h00 Travail personnel : 24h00 Durée totale: 56h00	Status	Periode Semester 5	Langue d'enseignement : English

Objectifs Généraux
At the end of this module, students should be able to: - Analyze structural systems to determine stresses, strains and stress concentration for axial, torsional and bending loads - Build shear and moment diagrams for simple structures in 2 dimensions. - Estimate the influence of internal forces on the deformation and analyze statically undeterminate systems - Utilize a numerical simulation software for stress analysis (Ansys Structural)

Objectifs Généraux

At the end of this module, students should be able to:
- Analyze structural systems to determine stresses, strains and stress concentration for axial, torsional and bending loads
- Build shear and moment diagrams for simple structures in 2 dimensions.
- Estimate the influence of internal forces on the deformation and analyze statically undeterminate systems
- Utilize a numerical simulation software for stress analysis (Ansys Structural)

Contenu
- Introduction: review of Statics and Solid Mechanics (stress and strain) - Axial loads: stress concentrations, stresses due to temperature change, solutions of hyperstatic systems - Torsional loads: torsion of shafts due to applied torques, design of transmission shafts, stress concentrations - Analysis of beams under later loads: shear and moment diagrams - Pure bending of beams: normal stresses, properties of cross-sections - Deflection of beams: elastic curve equation, resolution of hyperstatic systems

Contenu

- Introduction: review of Statics and Solid Mechanics (stress and strain)

- Axial loads: stress concentrations, stresses due to temperature change, solutions of hyperstatic systems

- Torsional loads: torsion of shafts due to applied torques, design of transmission shafts, stress concentrations

- Analysis of beams under later loads: shear and moment diagrams

- Pure bending of beams: normal stresses, properties of cross-sections

- Deflection of beams: elastic curve equation, resolution of hyperstatic systems

Prérequis
Solid Mechanics General Mechanics

Bibliographie
Essential textbooks: Hibbeler, R. (2018) Mechanics of Materials, 10th Edn., Pearson Education BeerF. et al. (2020) Mechanics of Materials, 8th Edn., McGraw Hill Recommended Textbooks: Anand, L. et al. (2022) Introduction to Mechanics of Solid Materials, OUP Oxford Raymond Parnes, "Solid Mechanics in Engineering",

Évaluation(s)
N°	Nature	Coefficient	Objectifs
1	Written exam	0,3	1 mid-term at the mid-course about the topics covered in the first half of the course: Review of statics, axial loads, torsion, shear and moment diagrams
2	Written exam	0,45	Final exam about all the concepts covered in the course. The exam consists of short questions as well as thorough analysis problems.
3	Practical work	0,15	Use of commercial FEM software: Axial, bending and torsional loads.
4	Continuous Assessment	0,1	Quizzes, general behavior in class